- This topic has 2 replies, 2 voices, and was last updated 12 years, 3 months ago by
.
-
Posts
-
Hi,
I have the above dishwasher and it seems like the dishwasher does not finish its cycles sometimes. I say sometimes as some days the cycles will complete, but some days it just keeps going for hours.
When it does go for hours, the pump is not going, there is no water in the bottom, but it gets hot and remains hot and steamy inside. It seems like it does not know when the drying period has finished as the items are clean inside and there is no water in the bottom and none coming out.
When a cycle fails to complete the dishwasher can be turned off and will start a fresh cycle fine, if I then choose the cold cycle that runs hot aswell.
I don’t believe this is a pumping issue, more of a sensor or control board issue.
I’m also guessing that this model seems to match many models from other manufacturers.
Have I described the issues well enough ?
any help is appreciated.
KR
PaulRe: LAM8301 Lamona Slimline Fully Integrated Dishwasher
Some Lamona’s are similar to Beko’s.
Sounds like a P.C.B problem to be honest.Re: LAM8301 Lamona Slimline Fully Integrated Dishwasher
Hi,
Thanks for the reply, how expensive is a control board ? is there a website/company I can find out the cost, once I’ve dug out the part number ? if its cheap I will replace myself.
And where would the PCB be situated, I’m assuming it would be in the door as I’ve taken this apart. Or would it be somewhere else ?
All help is gratefully received.
KR
Paul
- You must be logged in to reply to this topic.