- This topic has 1 reply, 2 voices, and was last updated 12 years, 2 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Display work fine and it starts up but on every setting it just pumps out then the start light flashes – nothing else on ANY program. Brushes are ok but there are a few odd slight burnt marks on the top of the comm above the carbon mark.
So is it as simple to say the motor is U/S or have I missed something? 😕
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.