Fisher and Paykel Washing Machine WA75T65GW1 00011110

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Fisher and Paykel Washing Machine WA75T65GW1 00011110

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 19, 2014 at 11:39 am #79083
    bobcox
    Participant

    Hi Binary Code is as above, cant find anything on Fault Code for this model.
    According to my older fault code listing for GW-IW its 30.

    Could you please advise what this fault code means for this model.
    WA75T65GW1 00011110

    Machine purchased in 2007, Sydney Australia.

    THank You

    January 21, 2014 at 3:06 am #407838
    FnPSteve
    Participant

    Re: Fisher and Paykel Washing Machine WA75T65GW1 00011110

    For this error code, it is linked to the Display Module and Motor Controller being out of sequence as far as I can remember. I will check newer information also, but they don’t usually change much.

    First action I suggest: Power off, unscrew top panel screws and ensure everything is correctly wired. Screw back on, plug in and check. Little things can cause Fisher & Paykel machines to beep / provide errors.

    If fault persists you will need to turn AUTO RESTART FEATURE OFF.

    Second Action – Enter DIAGNOSTIC MODE: Hold Wash Temp DOWN + POWER ON. LOW WATER LEVEL LED OFF = RESTART OFF. When the FIVE leftmost LED wash progress indicator lights are on, RESTART is OFF. Re-check.

    A new fault code should appear – which should provide a lot more specific instructions as this fault code is very vague and uncommon. If fault code doesn’t appear re-enter diagnostic mode and put Hold and Low Spin Speed LEDs on and it should display an error code – all is good, it should be different to the one you’re experiencing.

    This may help us identify what component is causing the problem.

    Worst Case Scenario: Motor Controller Module Replacement or Display Module. The uncommon errors are usually the worst I’m afraid. I don’t see these errors very often.

    January 21, 2014 at 5:48 am #407839
    bobcox
    Participant

    Re: Fisher and Paykel Washing Machine WA75T65GW1 00011110

    Thanks for your help and the information supplied.

    This machine will NOT allow entry into Diagnostic Mode, or anything else for that matter.

    Nothing alters the display sequence of lights which i now believe is Code 30 (00011110) with
    the “Out of Sequence” of Display Module and Motor Controller as you described.

    I suspect as you do the Motor Controller Board is faulty, needs replacement, or both.

    Thanks Again for your help, Much Appreciated.

    January 23, 2014 at 9:18 am #407840
    FnPSteve
    Participant

    Re: Fisher and Paykel Washing Machine WA75T65GW1 00011110

    No worries mate, sorry I couldn’t provide a quick fix. Some errors can be quite fatal I’m afraid. Good luck with your washing machine!

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.