Hotpoint FDYF 11011 DISHWASHER (H20 probs)

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Hotpoint FDYF 11011 DISHWASHER (H20 probs)

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 30, 2014 at 4:47 pm #79285
    steevann
    Participant

    I’ve had this d/washer since end of Nov 2013. Now it’s showing red tap and H2O in the digital read out. I’ve checked the pipes and they are not kinked in any way. Has anybody else had this problem? Does anybody have any idea why this is happening?

    January 30, 2014 at 7:07 pm #408701
    Seamy
    Participant

    Re: Hotpoint FDYF 11011 DISHWASHER (H20 probs)

    Have you had a look at the instruction manual?

    The dishwasher does not take any water in – Tap shut-off alarm
    (indicator light ON/OFF flashing; H2O and tap symbol displayed; F 6 appears after a few seconds).
    • There is no water in the mains supply.
    • The water inlet hose is bent (see Installation).
    • Turn on the tap and the appliance will start after a few minutes.
    • The appliance lock has been activated because no action was taken when the beeps sounded.
    Switch off the appliance using the ON/OFF button, turn on the tap and switch the appliance back on after a few seconds by pressing the same button. Re-program the appliance and restart the wash cycle.

    If still not curing problem, contact service as its only fairly new and still under guarantee.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.