Bosch dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch dishwasher

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 10, 2014 at 11:03 am #79456
    dpr1974
    Participant

    Morning, i don’t have a model number for this however here’s the problem. the inside isn’t all steel, the base is plastic and at the back where the steel is sealed to the plastic base it’s leaking. would it be as it appears and just a case of running a bead of adhesive sealant at the rear (outside) or are we talking about separating the two section to re seal it?

    many thanks

    David.

    February 10, 2014 at 9:35 pm #409322
    maltheviking
    Participant

    Re: Bosch dishwasher

    dpr1974 wrote:Morning, i don’t have a model number for this however here’s the problem. the inside isn’t all steel, the base is plastic and at the back where the steel is sealed to the plastic base it’s leaking. would it be as it appears and just a case of running a bead of adhesive sealant at the rear (outside) or are we talking about separating the two section to re seal it?

    many thanks

    David.
    These are well known for this problem, the plastic is the base unit and the tub sits into a groove, the problem is that the plastic “warps” so there is bugger all you can do with that. You will have a bit of a job to seal it because the moisture usually creeps out at the corners but worth a try.Not sure if the base unit is a spare part for you model if it is then it will no doubt be “Bosch” pricy 😯

    February 10, 2014 at 10:40 pm #409323
    dpr1974
    Participant

    Re: Bosch dishwasher

    I went ahead and used PU18 adhesive sealant and after three cycles it’s still dry. Shocked though that Bosch would move away from a one piece unit. Ta for your reply.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.