Hotpoint BFI260 Error

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BFI260 Error

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 24, 2014 at 4:15 pm #79687
    aqua_serve
    Participant

    Guys,

    Been to see a 9yo Hotpoint BFI62 dishwasher with a bit of a strange fault. The LEDs lit (l-r) are 1 & 3, this signifies a filter issue, however the machine isn’t heating the water, during the cycle. I’m thinking I’ve hit a board error but wouldn’t mind some of your opinions on it. From what I sure during a test on the ECO cycle the machine filled, washed but didn’t heat. After draining at about the 15 minute stage the machine faults with LEDs 1&3 highlighted.

    Sorry if it’s a garbled post, I’ve just dashed it off. If you need any further information please let me know.

    Mark

    February 24, 2014 at 5:10 pm #410224
    Hollytree_Technical
    Participant

    Re: Hotpoint BFI260 Error

    I would check the high pressure sensor as I have had a couple of them gunged up internally otherwise this may cure it.

    Jem

    February 24, 2014 at 9:12 pm #410225
    aqua_serve
    Participant

    Re: Hotpoint BFI260 Error

    Thanks Jem, as it happened I suspected the high pressure sensor, this was removed, cleaned along with the attached hoses and replaced. What I couldn’t understand was the lack of heat, would this be common with a high pressure sensor fault?

    Thanks for the details regarding the board, that looks of interest.

    Mark

    February 25, 2014 at 8:13 pm #410226
    HotDog
    Participant

    Re: Hotpoint BFI260 Error

    common fault board heater relay also early elements made by irca prone to fail

    February 25, 2014 at 10:14 pm #410227
    johnnyj
    Participant

    Re: Hotpoint BFI260 Error

    Getting a few now with the sump getting choked with gunge at the spigot for the pressure pipe causing this, a blast down it with a steam cleaner clears it, the newer style dishwashers are also showing this now not heating and a possible cause is the sump getting gunged up.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.