Bosch dishwasher SGS43T72uk/26 Fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch dishwasher SGS43T72uk/26 Fault

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 25, 2014 at 4:43 pm #79711
    asp11
    Participant

    Not sure about this fault – it’s not got an error code as far as I know but the Water light and Active light come on.

    It fills up fine then instead of starting to wash after it finishes filling up it just pumps out a little then fills a little…. and so on but does nothing else!!

    There is no leak in the base, all pipes are clean and the heater meters out ok. I think it’s the pcb but any other help n ideas would be great.

    Thanks

    February 25, 2014 at 4:53 pm #410296
    Andy jones
    Participant

    Re: Bosch dishwasher SGS43172uk/26 Fault

    Impeller jug

    February 25, 2014 at 4:56 pm #410297
    Andy jones
    Participant

    Re: Bosch dishwasher SGS43172uk/26 Fault

    Although I can’t seem to get model no to work

    February 25, 2014 at 5:09 pm #410298
    Martin
    Participant

    Re: Bosch dishwasher SGS43172uk/26 Fault

    SGS43T72UK/26 and a need to pop into Specsavers before fitting the Impellor Jug (00424099) 😉

    February 25, 2014 at 5:25 pm #410299
    asp11
    Participant

    Re: Bosch dishwasher SGS43T72uk/26 Fault

    I did think it was the impellor jug before I arrived at the house but my past experience on jug problems is that the machine doesn’t fill up properly at all – it only fills n empties from the start but this machine does fill up properly, stops…. then fills n empties!!

    February 25, 2014 at 7:07 pm #410300
    Martin
    Participant

    Re: Bosch dishwasher SGS43T72uk/26 Fault

    Always carry an Impellor Jug as van stock, they’re cheap and easy to fit…..way to go!

    February 26, 2014 at 12:11 pm #410301
    asp11
    Participant

    Re: Bosch dishwasher SGS43T72uk/26 Fault

    THANKS Martin

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.