- This topic has 5 replies, 2 voices, and was last updated 12 years, 1 month ago by
.
-
Posts
-
Just brought my WDL520 washer dryer back out of storage. Used it for the 1st time no problems but now has developed a fault.
The machine starts a program fine but roughly 10mins into the program the fault occurs. The machine flashes a set of lights and I can hear both water in the powder tray and the waste pump running at the same time. The machine get stuck like this until I turn the mains power off. All programs are affected and the same happen when it is running the dryer function.
Photo below of the flashing lights. All the bottom lights are flashing and the other two on the side are on constantly.
Anyone experienced a fault like this before or know a fix?
Re: Hotpoint WDL520 washer dryer
Need to know which of the right hand vertical lights are on steady, by number from bottom up if possible.
Re: Hotpoint WDL520 washer dryer
The vertical lights on the right hand side are like the pic.
Top four are off and the bottom two “end” and the “Key” are constantly on.
Re: Hotpoint WDL520 washer dryer
Your picture does not show the vertical lights??
However, just found out that if I click and hold then move the pic it does, someone has been tinkering with the forum settings. 😀
Fault code is.
F03 NTC short/open circuit: Check thermistor and module connections
Re: Hotpoint WDL520 washer dryer
Just doing some digging on the thermistor, which one does that fault code relate too.
or
- You must be logged in to reply to this topic.