- This topic has 4 replies, 3 voices, and was last updated 12 years ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
-
Posts
-
Indesit washer dryer IWDC6105UK not pumping.. will fill/spin etc but no pump.. comes on for a 👿 few seconds then no power to pump. Have read of possible faulty ntc and also of level system faults.. gut felling is module but they then need programming and I have no programmer 😡 customer is keen for repair :rolls: advise appreciated
OscarRe: Indesit IWDC6105UK no pump
if you mean pump comes on for a few seconds then goes off then that is usually the dryer ntc or wiring at ntc 😉
KevRe: Indesit IWDC6105UK no pump
I would get a module from EMW which are already programmed for YOUR model.If it doesn’t cure the fault then you know for certain its a component or wiring fault, and you can return it for £7.20.
Bob
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.