- This topic has 4 replies, 2 voices, and was last updated 11 years, 12 months ago by
.
-
Posts
-
Hi guys,
My friend has the above that doesn’t work.
I know it’s a pile of junk but I thought I’d help out.COD 37490430900
S/n 911120786After scraping the filters clean and trying a wash the washer stops and drains with warning lights 2 and 4 flashing ( normal wash and Eco )
The soak function appears to work correctly all the time.
Heater?
Any help would be much appreciated.
Jez
Re: Hotpoint LFT 114 warning lights
Error codes HERE
Both heater and pcb prone to failure on these. 😥
Re: Hotpoint LFT 114 warning lights
Thanks iadom,
As it happens after the cold wash finished, a little while after the machine just started the pump back up and kept running and when I opened the door 2&4 were flashing again.
Guess that points to the pcb if it just decides to do something on its own?
I did look in the error codes but didn’t see the LFT? Sorry.
Thanks
Re: Hotpoint LFT 114 warning lights
The link in my post is for the FDL codes which are the same as your machine, just a different pile of Indesit ****.
You need to test the heating element first before you assume anything, also check for continuity from pcb to heater. The element is around £50 but the pcb is more and also needs programming, something you will not be able to do unless you fork out over £120 for a smart card and card reader as well as the £70 or so for the pcb. :rolls:
- You must be logged in to reply to this topic.