- This topic has 3 replies, 2 voices, and was last updated 11 years, 11 months ago by
.
-
Posts
-
Hi guys anyone have info on these integrated larder freezer temp on display at 6 but me digi stat reafs – 12 still too high im sure its a sensor but which one i checked resistance 3 pairs of red and blue wires going to the pcb zero ohms on one pair , 6 k ohms , and 8 k ohms on the other 2 thanks
Re: liebherr IGN 2566 temp too high
Hi mate, sorry just seen this. The IGN is an integrated freezer. Is the fan running? Is the evaporator over frosted?
There are two sensors on this one, air sensor and evap sensor. Normally 9590148 but that would depend on the service number of the appliance.
The evaporator is accessible from inside the cabinet, so you’ll be able to check the fan. You can also check the heater from the pcb, but that’s not likely to be honest.Re: liebherr IGN 2566 temp too high
Yeah fan running and ice visible on back panel , serv no 9981212-05
Re: liebherr IGN 2566 temp too high
On the back panel? The evap is at the top on this one. There shouldn’t be any ice at the back. It’s not a complicated appliance. I’d be checking that the evap isn’t over frosted. If it is, check the heater and thermal fuse. It they’re ok, then it’s likely to be a sensor fault, or at worst, a pcb fault.
- You must be logged in to reply to this topic.