Hotpoint WML 520P no heat

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WML 520P no heat

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 18, 2014 at 10:19 pm #81130
    Madmac
    Participant

    Or more accurately practically no heat 😯 Customer complained machine sticks on wash and wont advance, put meter on heater terminals when it was on wash and got a couple of 230 volt bursts lasting a few seconds having sat staring at the meter for 10 mins or so 😕

    No dry joints on relays, even tried tapping relays when it was running but no joy.
    EMW dont seem to do these late small boards.

    Skip fodder ❓ 🙂

    Eddie.

    June 19, 2014 at 7:18 am #415411
    Martin
    Participant

    Re: Hotpoint WML 520P no heat

    Madmac wrote:Skip fodder ❓ 🙂

    Yes! For the PCB at the very least I would say. Though a few of the guys on here that stand steadfast in the face of adversity would be in there with their solder suckers and hot irons gently coaxing a new relay into position. Too much for me I have to admit and into the skip it goes. :clown:

    June 19, 2014 at 10:55 pm #415412
    Madmac
    Participant

    Re: Hotpoint WML 520P no heat

    Probably where it’ll end up ,although I have had luck replacing the common 12v 5 pin relays used on this board I’m not convinced thats the problem, absolutely no sign of overheating.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.