bush A127qb Drain hose question.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bush A127qb Drain hose question.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 20, 2014 at 12:17 pm #81155
    den
    Participant

    Went to connect a customers new washing machine… a crappy Bush!
    Draining very very slowly. Whipped the drain hose off the drain stub.
    Looking down the drain hose there is what appears to be a non-return valve wedged in the hose about a couple of inches down.

    This seems to fill most of the hose, only allowing the water to escape through the small gap surrounding the ‘valve’

    Never came across this stupid device before. (the rubber flap valves were bad enough. this is worse!)

    Anyone else found this?

    June 20, 2014 at 3:21 pm #415656
    Martin
    Participant

    Re: bush A127qb Drain hose question.

    No doubt would cause a number of strange ‘beating’ noises behind? :clown:

    June 20, 2014 at 5:10 pm #415657
    BobHope
    Participant

    Re: bush A127qb Drain hose question.

    thsts not part of the drain hose it will be from an old non return valve, just remove it.

    Bob.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.