Candy GC4 1472D1/1-80 start-stop etc

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Candy GC4 1472D1/1-80 start-stop etc

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 8, 2014 at 3:56 pm #81381
    asp11
    Participant

    This is a very weird fault, you can select any program fine but when it starts, it shows the displayed cycle you’ve chosen but all it then does is start, stop — start, stop ETC

    It won’t continue at all just keep on doing that, the display comes n goes as it’s doing it.

    This app doesn’t have that selector switch behind the knob that used to be a big problem, it has the knob shaft going into a pcb. I’m guessing it must be the main lower board at fault but just wanted to see if anyone else has had this error before?

    Thanks :rolls:

    July 8, 2014 at 4:16 pm #416416
    Martin
    Participant

    Re: Candy GC4 1472D1/1-80 start-stop etc

    Then it could be the board at fault. Have you meggered the machine as that will throw up all sorts of weird probs if the insulation is low otherwise.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.