Rangemaster Range cooker change door receiver catch

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Rangemaster Range cooker change door receiver catch

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 17, 2014 at 10:50 am #81496
    Rograbbit
    Participant

    Hi got to replace door receiver catch, you know the rolled spring type. Anyone know if I get access from side,front,or rear on these?
    Thanks.

    July 17, 2014 at 1:43 pm #416831
    eastlmark
    Moderator

    Re: Rangemaster Range cooker change door receiver catch

    Rograbbit wrote:Hi got to replace door receiver catch, you know the rolled spring type. Anyone know if I get access from side,front,or rear on these?
    Thanks.

    Its in the door isn’t it?

    July 17, 2014 at 3:41 pm #416832
    Rograbbit
    Participant

    Re: Rangemaster Range cooker change door receiver catch

    Don’t know ,should have said going next week. If it’s in the door then that’s great, presume I just split door?

    July 17, 2014 at 9:55 pm #416833
    eastlmark
    Moderator

    Re: Rangemaster Range cooker change door receiver catch

    yes remove a few screws around the edge of the door and you can open it just enough to access the roller catch. Often find, even with gen parts the holes for the screws never seem to line up on these and a small round file is needed. Assuming you are talking about a British rangemaster, Turkey ones may be different.

    July 18, 2014 at 11:36 am #416834
    Rograbbit
    Participant

    Re: Rangemaster Range cooker change door receiver catch

    Thanks for that. Customer hasn’t given me many details, but will go and have a look. Have got a Hotpoint one in stock, would be nice if that would fit, we’ll see. Thanks again.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.