How to get at bearings on Blomberg

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › How to get at bearings on Blomberg

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 20, 2014 at 10:27 am #81530
    andrewjb
    Participant

    My Blomberg 1301 ABB doesn’t turn well – the inner drum doesn’t seem to be concentric to the outer drum and rubs when turning. Thus I’m suspecting bearings?
    So… how do you get at them on this model? Attach from the front (panel off, inner drum out?) or from the back? Suggestions would be greatly received before I go in the wrong way!

    July 20, 2014 at 11:07 am #416922
    Martin
    Participant

    Re: How to get at bearings on Blomberg

    Not only the bearings but the drum shaft will also be knacked. Full strip down of drum to access the damage. A costly excercise overall. 🙁

    July 20, 2014 at 1:31 pm #416923
    andrewjb
    Participant

    Re: How to get at bearings on Blomberg

    Ok. Got in! Bearings look and feel fine. But the bracket (spider?) on the back of the inner drum is cracked. Is the drum or bracket still available as a replacement part anywhere? I can’t find one. It is 13 years old by now..

    July 20, 2014 at 1:56 pm #416924
    Martin
    Participant

    How to get at bearings on Blomberg

    The odds of finding one aren’t too brilliant. eBay maybe?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.