- This topic has 6 replies, 3 voices, and was last updated 11 years, 8 months ago by
.
-
Posts
-
Hi
called to this unit on Thursday and found unit trying to go into spin then shutting motor down. Sounded like a taco fault so checked wiring from module through motor and found that I had 132 ohms for taco. Ordered 904/2426/02 time/module from EMW which I fitted today but still have the same problem of motor going into uncontrollable spin.
Will send unit back to EMW to check but is the anything else that could cause this?Geoff
Re: Hotpoint WD62
Sounds like wiring problem. Have you double checked where wiring is cable tied to motor, they where prone to rubbing through there
Sent from my iPad using Tapatalk HDRe: Hotpoint WD62
Hi Andy
I checked there and pulled plugs off at both ends to test cables which were OK
Geoff
Re: Hotpoint WD62
What type of motor is fitted. The tacho magnet on the FHP motors can and does come loose but it is not easy to see unless you look very closely.
I have managed to re secure them using loctite in the past, often without having to remove that silly metal disc that holds the tacho in place with reasonable success.
Re: Hotpoint WD62
Hi Jim
I will check when I go back as I only checked coil and did not think of magnet.
Geoff
- You must be logged in to reply to this topic.