Hoover VHV 680c PCB?

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Hoover VHV 680c PCB?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 28, 2014 at 2:44 pm #82011
    Doo
    Participant

    My VHV 680c vented dryer stops after a few minutes on all settings and then the LEDs flash continually . There is no heat but the element seems fine on a continuity test. I think the fault is the PCB that is now discontinued and not available . Any advice before I buy a new machine ( other than don’t buy Hooover? )

    August 28, 2014 at 4:15 pm #418411
    Martin
    Participant

    Re: Hoover VHV 680c PCB?

    Count the flashes. There is a slight pause and the flashes repeat. The flash count gives the all important error code.

    August 29, 2014 at 10:35 am #418412
    Doo
    Participant

    Re: Hoover VHV 680c PCB?

    Hi Martin
    The LEDs just keep flashing- no pause so I can’t figure out an error code

    August 29, 2014 at 10:41 am #418413
    Martin
    Participant

    Re: Hoover VHV 680c PCB?

    Shucks, that’s too bad then. 🙁

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.