- This topic has 4 replies, 2 voices, and was last updated 11 years, 7 months ago by
.
-
Posts
-
Morning All,
last week our washing machine caused a mcb to trip out, when I sorted that out it was displaying E01, which according to the error code help suggests that there is a problem with the door interlock.
So I replaced that module but it still displayed E01, investigating further one of the fuse tracks on the controller PCB had blown. So I’ve replaced that this morning but on doing a test (did drain program first, then a rinse and spin) then same fuse track has blown again, along with the other one.
Any suggestions
Cheers
Steve
Re: Hoover DYN8164D Controller Board
Sounds like a motor fault. When it blows the board to bits it shows a door lock error just to keep you guessing! Had it on many occasions. Check the rectifier pcb also as it tends to affect that too.
Nige
Re: Hoover DYN8164D Controller Board
Hi Nige,
is the rectifier PCB mounted on the motor? Apart from the controller I’ve only seen the RF suppression cap.
Cheers
Steve
Re: Hoover DYN8164D Controller Board
Hi Nige,
OK the rectifier has 3 burn out tracks, I can’t see any scorching on the motor.
So is the root cause here the rectifier, or would something else have drawn too much current to burn out the rectifier?
Cheers
Steve
- You must be logged in to reply to this topic.