- This topic has 3 replies, 3 voices, and was last updated 11 years, 6 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
hi please can someone advise on fitting this heater,as the leads are not long enough to replace through the hole in back of machine do i need to take off the front ? thanks john
Re: hoover vhc392t fitting heater
Wrong forum should be trade tech. But anyway access from front on this heap of junk.
Re: hoover vhc392t fitting heater
Do it from the back! Twist a few strands of wire together and knot it through the Ty wrap clip before pushing it into the machine, as you pull out the old heater wires you can then put the few strands of wire on the new Ty wrap clip of the new heater and gently pull through. (Make sure it’s a good length of wire). I have also managed to clip it in with my little finger…
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.