Hoover DYN8164D-80 F-08

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover DYN8164D-80 F-08

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 27, 2014 at 3:39 pm #82392
    Profyaffle
    Participant

    Hi Guys,
    enlighten me please,
    I’m getting Error 8 on the display here, Checked CESET motor through the Tacho and getting just around 42Ohms. As I found an irregular scoring on one of the Carbons I replaced them and the machine filled and started running as per normal.
    I reset the machine and ran a full spin program which it finished without issue.
    A while later I get a phone call informing me that the F08 has returned.
    The Armature and Tacho were removed and cleaned from carbon,the wires for the Tacho were checked and are in good condition.
    Is 42Ohms at Tacho correct for the Ceset motor?
    Board Fault?
    Any Tech Info(Service manual) would be greatful
    Chris

    September 27, 2014 at 3:48 pm #419706
    Martin
    Participant

    Re: Hoover DYN8164D-80 F-08

    Are you sure it is F08 and not E:08?

    September 27, 2014 at 5:14 pm #419707
    Profyaffle
    Participant

    Re: Hoover DYN8164D-80 F-08

    Your right Martin, it is E08

    September 27, 2014 at 5:36 pm #419708
    Martin
    Participant

    Re: Hoover DYN8164D-80 F-08

    Profyaffle wrote:Is 42Ohms at Tacho correct for the Ceset motor?

    I meant to reply to this earlier……yes spot on!

    September 27, 2014 at 6:47 pm #419709
    Profyaffle
    Participant

    Re: Hoover DYN8164D-80 F-08

    So we’re talking Board fault then?

    September 27, 2014 at 8:23 pm #419710
    Martin
    Participant

    Re: Hoover DYN8164D-80 F-08

    Profyaffle wrote:So we’re talking Board fault then?

    I wouldn’t say so. If the board were faulty it wouldn’t recognise the error in the first place! More likely a break between the tacho and the board or a spurious earth leak perhaps?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.