How to fit hose and tray compressor

Home › Forums › Public Support Forums › Help And Support › Fridge And Freezer Forum › How to fit hose and tray compressor

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 29, 2014 at 10:34 am #82402
    evz
    Participant

    Hi,
    Hope someone can help?!

    I have a Whirlpool ARC5551. I discovered that the condensation hose at the back of the fridge had disintegrated and also the tray compressor.

    I have now bought a new hose and tray from 4ourhouse.

    I am now wondering how to fix them to the fridge?

    Would I pop the hose in the hole at the back and run it down and lay the tray compressor on top of the compressor so the hose reaches in to the tray. Do I need to fix the hose at the top with anything?

    Thanks,
    Ester

    October 2, 2014 at 5:05 pm #419742
    Seamy
    Participant

    Re: How to fit hose and tray compressor

    Theres normally a spout coming out from fridge at rear, the condenser at back sometimes hides the connection. If you carefully take off the condenser you should get at it. Pipe then should run down & terminate in tray. Tray normally either fixes on with clip or is stuck onto top of compressor. If you have difficulty doing this, would advise to get a service engineer to look at it for you.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.