Indesit Plastic Drum Pulley part no.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Indesit Plastic Drum Pulley part no.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 2, 2014 at 11:49 am #82451
    MickGeorge
    Participant

    Hi Folks

    Has anybody got the part no. for this drum pulley? Hotpoint, Connect and Qualtex all saying it is a metal pulley fitted but the pulley fitted is plastic and fits a splined shaft (much like the Hoover m/c’s).

    Indesit Model No. WIB111(UK)
    Ser. No. 807304126
    Prod No. 46464700200

    It maybe the tub asy might have been changed to a later one or posibly Indesit have discontinued the plastic pulley and you have to have a complete tub asy change now (which wouldn’t surprise me these days) :rolls:

    Just need someone with a bit of experience to come up with a part no other than some one who can only operate within the parameters of a computer!

    Thanks

    Mick

    October 2, 2014 at 4:25 pm #419901
    iadom
    Moderator

    Re: Indesit Plastic Drum Pulley part no.

    Partfinder only shows what appears to be the metal pulley and a very small, smudged diagram of the earlier split drum that is virtually useless.

    The plastic pulley for the Hotpoint and other Indesit models is C007270717. :con:

    October 3, 2014 at 9:27 am #419902
    MickGeorge
    Participant

    Re: Indesit Plastic Drum Pulley part no.

    Thanks for the reply Jim

    Think that part no is C00270717 ?

    Think I found that one when I was searching under “Indesit Drum Pulley” on spares sites. Looking at picture it fits a double flat round drum shaft where as the the drum shaft fitted is a splined shaft.

    Might put this on the tech. forum see if there is any of the Hotpoint guys come across this.

    Wouldn’t surprise me if Indesit bought a batch of these drum assemblies cheap then the manufacturer went bump after they drove the price down – hence no spares listed for it.

    Pulley had come loose and worn the pulley hole – just wanted to replace pulley incase it came loose again. Looks like it might be a Locktight and big hammer job!

    Thanks again

    Mick

    October 11, 2014 at 8:34 am #419903
    MickGeorge
    Participant

    Re: Indesit Plastic Drum Pulley part no.

    On revist to this found this wasn’t a splined shaft it was a double flat shaft 😳 (could have sworn it was splined but couldn’t have taken it off but just felt the play) so the part number you gave me was the right one.

    Think I must have had a senior moment then! Maybe it’s getting time to retire!

    Thanks again.

    Mick

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.