- This topic has 5 replies, 3 voices, and was last updated 21 years, 1 month ago by
.
-
Posts
-
This machine has developed a leak from the bottom of the metal band that surrounds the rear of the drum- cosequently the water is dripping onto the motor plug/socket and preventing it from spinning. Does anybody know if there is a seal in the rear of the drum underneath that metal bracket and if so what it is called -part no. etc. thanks.
Yes Reddy there is a seal there but if it’s dripped onto the motor the chances are that the module will be blown if not the motor itself as well.
Drip protection at factory about 3p, if that…
Cost to put it right when the motor gets wet… about £200!
K.
It’s still working but dripping, so i’ve put plastic bag over motor connector block for now. I just wondered if anyone knows the ‘cure’ or part no. or description for the seal at the reaer of the drum. Thanks
Reddy wrote:It’s still working but dripping, so i’ve put plastic bag over motor connector block for now. I just wondered if anyone knows the ‘cure’ or part no. or description for the seal at the reaer of the drum. Thanks
If your machine has a metal rear drum backplate then you will need the gasket replacement part no: C00103637.
If the backplate is plastic then its part no: C00040897, both available direct from Indesit spares dept 0870 9077077 😀
Martin
- You must be logged in to reply to this topic.