Bosch wvd24520gb/01 washer dryer module lock down!!

Home Forums Trade Technical & Spare Parts Forums Trade Technical Enquiries Bosch wvd24520gb/01 washer dryer module lock down!!

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #82622
    davem
    Participant

    Hi Guys,

    I have a Bosch WVD24520Gb/01 washer dryer. The carbon brushes were worn so replaced as normal, but when i turn the machine back on the display panel lights up but non of the buttons work and no programs show on the display. It’s like the module has gone into lock-down!!

    I’ve inspected the module and all looks fine.
    I’ve tried turning the dial to 6 o’clock while pushing the spin button and so on, but to mo avail!!!

    No fault code shows, just a lite up display with no programs on it.

    HELP…………………..

    Paul

    #420423
    Martin
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    You should post this stuff in Trade Technical Dave. 🙁

    Was the display and control buttons OK before you changed the brushes? Also, have you tried pressing and holding the start button for 5secs?

    #420424
    davem
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    Sorry about posting in wrong place! I am fairly new to forum

    control module had gone into lock-down before I changes the brushes and Yes, tried pushing start button.

    #420425
    timdowning
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    Certainly an out of circuit motor gives you those display issues. Assuming brushes and wiring are good then motor is the issue.

    #420426
    cornwell40
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    I know it’s an old thread but has anyone else resolved this fault.

    Same symptoms, display just showing backlight on a machine to recon. Meggered machine all ok, didn’t think of brushes at the time so tested it with a a board /facia froma donor machine. Machine sailed through first was with no problems or undue noise/ arcing. Tried it on second wash and noticed no motor action after a while. Turned of, check the brushes and well down. Changed them and the display has reverted to backlight only.

    Tried the donor machine motor, checked the edge connectors, buzzed out loom…all ok. Presuming that the brushes have taken the pcb out as the old motor test through fine.

    Surrounded by bits now and thoroughly peed off as both these machines were mint. 🙁

    #420427
    Martin
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    Has the motor triac blown on the board?

    #420428
    cornwell40
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    Can’t see anything visibly blown but must admit I was looking with the naked… readers 😉 Will get my magnifier out and look again.

    #420429
    cornwell40
    Participant

    Re: Bosch wvd24520gb/01 washer dryer module lock down!!

    All triacs looking fine. One of those boards with the see through rubberized gunk sealing everything though 👿

Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.