Hoover VT 816D22

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hoover VT 816D22

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 6, 2014 at 10:46 pm #82937
    cskasofia
    Participant

    Got the above mentioned washing machine.

    I had to remove the board behind the programme selector switch, (its a rotary type switch, with contacts that directly touch the board). As well as selecting the programme, the switch powers the machine up.

    After refitting the board, the washing machine now doesn’t power up. Does anyone have any experience with these rotary type switches, or offer any possible solutions.?

    November 7, 2014 at 9:41 am #421197
    electrofix
    Moderator

    Re: Hoover VT 816D22

    from what i can see the whole front board is not that expensive
    part no 41035005
    but
    it depends on what you mean about wont power up

    do you mean
    A no light or power at all
    B has light but wont start programme

    if it A then this front panel is only a slave board and the is a link between the 2 boards. make sure the wire is secure at both ends
    if it B then it could be just the front board if you have made a mess of the switch

    Dave

    November 7, 2014 at 1:29 pm #421198
    cskasofia
    Participant

    Re: Hoover VT 816D22

    The unit is not powering up at all.

    Do you have a link to that part number?

    Regards

    November 7, 2014 at 2:00 pm #421199
    electrofix
    Moderator

    Re: Hoover VT 816D22

    first check the wire that goes between the panel and the main pcb. its very likely you have disturbed the connection one end or the other. also check there is power coming in. would not be the first time a customer was going to scrap a machine for a faulty socket

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.