Beko DW601 light no 3 flashing

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko DW601 light no 3 flashing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 16, 2014 at 8:26 am #83033
    Gregory55
    Participant

    Hello,

    My Beko DW601 has a flashing 3rd light along (Eco 50 cycle) when switched on. Programme and start buttons won’t respond. Holding down start button to cancel stops the light flashing but still no response from controls. Going into test mode and running the test cycle works OK with no error codes, but it still won’t run a normal cycle. Have replaced the NTC which is usually associated with the 3rd light error, but no change. Wiring looks fine, everything squeaky clean and dry underneath. Only two years old (just out of warranty!). Any ideas? Thanks.

    November 18, 2014 at 9:54 am #421515
    Seamy
    Participant

    Re: Beko DW601 light no 3 flashing

    3rd program indicator light on means NTC fault, cabling down the door to base is prone to breakage especially on the fine cable to NTC & Flowmeter, try a little tug on each wire in turn & you may fine one will come with you. Otherwise it could be a dodgy PCB.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.