- This topic has 0 replies, 1 voice, and was last updated 11 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Our drier would not heat up and so I replaced the heating element and stats. When doing this cleaned loads of wet fluff from inside and the condenser was completely bunged up. Anyhow cleaned everything up but now it is overheating and the timer control sticks (I am guessing this is because it is too hot) I am wondering if I have got the wires and stats the wrong way round. Is there a diagram available for down load? Any advice much appreciated.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.