- This topic has 3 replies, 2 voices, and was last updated 11 years, 4 months ago by
.
-
Posts
-
Two problems with this one:
1. It would intermittently throw up an E10 error on drying cycles (no problems on washes). I believe this is related to water supply to the condenser, so a new 3-way valve is required?
2. More seriously, it now won’t run any program: wash, spin or dry. It shows the expected time remaining, but a few seconds after pressing Start, the time changes to “1” and it skips straight to the end of the program and unlocks the door. (edit – no error code is displayed when it does this).
I have searched but didn’t find any other references to this problem. Any ideas? Thanks in advance.
Re: AEG L75480WD Problems
Most problems on these are caused by the dryer heating element going low to ground, you would need to test with a Megger to confirm.
E10 is normally the coil of the 3 way valve going open circuit during the programme, new valve normally cures it.Re: AEG L75480WD Problems
Thanks for the reply. I was hoping someone had seen this problem before, but it seems not.
Re: AEG L75480WD Problems
Seamy wrote:Most problems on these are caused by the dryer heating element going low to ground, you would need to test with a Megger to confirm.
E10 is normally the coil of the 3 way valve going open circuit during the programme, new valve normally cures it.I have seen these problem dozens of times before thats why i posted .
- You must be logged in to reply to this topic.