bosch wte6920 belt fitting

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch wte6920 belt fitting

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 11, 2014 at 2:16 pm #83380
    delta01
    Participant

    hi can anyone give me a clue as to how easy it is to fit a belt to this model please ,am going tommorow not done one before
    thanks john

    December 11, 2014 at 2:47 pm #422614
    Martin
    Participant

    Re: bosch wte6920 belt fitting

    Should post this in trade tech forum. Mods please move it.

    I’ve posted this answer many times I’ve lost count TBH. (sigh)

    R/H panel, heater cover and lid off.
    Remove nut holding on front fan.
    Release tension spring, motor connector block and plastic latch to right of motor.
    Release motor shaft clamp and withdraw motor and rear fan out of the back sufficient to thread drum belt into motor shaft.
    Release enough screws securing rear panel and rear bearing circlip sufficient to threading belt around rear shaft and onto the tub.
    Reassemble in reverse order.

    If I’ve overlooked anything I apologise as I’m replying to you whilst waiting for some twat of surveyor inspects a property I’m selling. He keeps interrupting my line of thought asking pointless questions :rolls:

    December 11, 2014 at 4:09 pm #422615
    delta01
    Participant

    Re: bosch wte6920 belt fitting

    Thanks Martin
    sorry i keep posting in wrong forum will endeavour to get it right next time thanks for info

    John

    December 11, 2014 at 4:17 pm #422616
    Martin
    Participant

    Re: bosch wte6920 belt fitting

    Oh! Just realised. You don’t need to withdraw motor (only unless you change the small motor drive belt) the main drum belt goes around the secondary pulley. However best policy is replace BOTH belts as they wear equally.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.