- This topic has 6 replies, 4 voices, and was last updated 11 years, 3 months ago by
.
-
Posts
-
Hotpoint washer aq113d697euk had a board fitted from emw it works fine switch it off then the next day it will not switch back on unless you pull the plug out and back in or switch on and off at socket,sent the board back they said it was ok but sent a different but it does the same. fault on the original board was would not rest after being tipped up with water in. anyone have a clue why it does this?
dopRe: strange one
I presume you have cleaned the air chamber and replaced the pressure switch as well?
Re: strange one
didnt change the switch but would that have a no power problem, it work fine after plug out and back in
Re: strange one
Dunno Dop, just guessing. Jim is the Aqualtis expert, he should come back to you on that soon I expect.:D
Re: strange one
To be honest I see very few of the Aqualtis machines.They were grossly overpriced for an Indesit and the folk round here can often spot someone in ‘fur coat and no knickers’ 😉 . Most of the ones I have done have been blocked pumps, door seals and broken concrete weights.
Never changed any pcb’s on them.
strange one
It’s the standby function. They introduced a standby function 2010/11 to meet new Eu regulations. When the machine is left unused it enters deep standby and you can’t turn it back on. Only way to wake it up is cycle mains power.
It’s one of 3 things causing it, either the wrong board as some machines have 2 versions depending on the age, both will work but one has standby and one does not
t has the wrong EPROM file uploaded again same as board two available and finally but I don’t think this affected the aqualtis it needs a new module to display card cable fitted. Pre standby boards had a 4 wire harness but the new standby ones have a 5th wire for that function ,
Post the commercial code and serial number and I’ll find out which one it is giving you the problem.
If I was a betting man it’s the wrong board
- You must be logged in to reply to this topic.