- This topic has 9 replies, 3 voices, and was last updated 11 years, 3 months ago by
.
-
Posts
-
hi guys i replaced an evap sensor in this one , now the digital temp display is up at 15 degrees food is still cold just not cold enough anyone come across this one , has anyone tech info on the sensor values service no. 9985258-05
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
as a rule, the values are:
temp/ ohms
+35 3.1
+30 3.8
+25 4.7
+20 5.9
+15 7.3
+10 9.3
+5 11.9
0 15.3
-5 19.8
-10 25.9
-15 34.1
-20 45.3
-25 60.8
-30 82.3
-35 112.8Re: liebherr ikb 3650 larder fridge temp on display 15 degre
that would be kohms right ? i have 3.65 kohms at 6 degrees for the evap sensor
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
slyp98 wrote:that would be kohms right ? i have 3.65 kohms at 6 degrees for the evap sensor
correct yes! should have pointed that out! I cut and pasted from a table that left that information out.
Are you certain you have the correct sensor? (9590142) and have you used that connector plug they supply with it correctly?
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
eastlmark wrote:
slyp98 wrote:
that would be kohms right ? i have 3.65 kohms at 6 degrees for the evap sensorcorrect yes! should have pointed that out! I cut and pasted from a table that left that information out.
Are you certain you have the correct sensor? (9590142) and have you used that connector plug they supply with it correctly?
i ordered the sensor kit from NAA , i installed kit but fridge still stuck on 15 degrees , temp of evap is only 6 degrees , pcb board ??
Re: liebherr ikb 3650 larder fridge temp on display 15 degre
Is the compressor running when it is showing 15 deg ?
If the compressor is hot and running it may be a refrigerant fault.
If the compressor cuts out then it is normaly a sensor fault.
Unlikely to be a PCB.
BobRe: liebherr ikb 3650 larder fridge temp on display 15 degre
the compressor is hot not overly hot though it wasnt running when i got at it (integrated ) the food is cold enough 5 to 6 degrees but the display will never go to what you set it at , i also noticed the wooden base the fridge is sitting on is almost closed off to any air coming up to cool the compressor the sides are open 100mm gap all round and the top is open again 100mm , would this cause the comp to overheat , why would the led display not show the correct temp inside the fridge, its not 13 degrees in there
- You must be logged in to reply to this topic.