- This topic has 4 replies, 2 voices, and was last updated 11 years, 2 months ago by
.
-
Posts
-
Hi all i have a beko wme7267w that seems to stick and then reset the program, on the spin and drain it sticks at 18mins hangs for a while then resets to beginning of the program, i can hear a relay at the point where i think it should fast spin, took the board out and all looks good cleaned with some electrical cleaner and the brushes look like there is at least 6 months on them, also i am running this empty so i wouldn’t think it a balancing problem as it does it both full and empty. Any pointers would be great cheers all jim
Re: Beko wme7267w not going into fast spin
Check the usual suspects, heater low, motor low, pressure vessel blocked etc.
Is it E18 fault code perhaps that comes up on it instead of 18 minutes left?
E18 is unbalanced load.
The appliance could be aborting because of blocked pressure vessel giving false excess foam signal either.Re: Beko wme7267w not going into fast spin
No its definitely 18 mins left when I first got it it had e11 when I put it through test so investigating the motor but I had cleared it and hadn’t shown since have checked pressure pipe seems clear and changed float switch with a spare but no difference
Re: Beko wme7267w not going into fast spin
Yes sorry getting dryers and washer mixed trying to fix one of each at same time think I’ve cracked it one off the wires at the block has sheared so I’ll repair it in morning as I need a smaller female terminal and should be good to go I’ll report back when I’ve tested it. Not so good news on dryer though it seems a beko As well looks like thermostat has small hole in it has gone to earth and fried board to much damage to even start a repair as number of tracks gone plus components. Thank you for your time it’s what I think is great with forums
- You must be logged in to reply to this topic.