ISE 23W Washing machine problems

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › ISE 23W Washing machine problems

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 4, 2015 at 1:40 pm #83969
    John Dee
    Participant

    I have an ISE23W

    (I note ISE are currently in closed for buisiness)

    The machine still works however I have 2 problems

    1. it is now incredibly noisey when spinning. It sounds like some kind of bearing may either be going or just need oiling.

    Can anybody offer any advice on likely repair requirements and whether it may be cost effective. Where is the oil hole?

    2. The basic design fault of this model has struck again (I already had this repair once under warranty) and the main water inlet (the black plastic/rubber concertina-e pipe thingy) to the drum is starting to leak due to chaffing of the main drum on the part. Currently I have caught this early enough to bodge it and refit my protection system, but are spair parts now avaialble as ise are now closed.

    Thanks

    February 4, 2015 at 2:10 pm #424392
    iadom
    Moderator

    Re: ISE 23W Washing machine problems

    There is no ‘oil hole’ on this or virtually any washing machine bearings.

    The bearings are not expensive and are quite a straightforward change if done in good time.

    With reference to the hose chafing I always stretch the small spring at the back, this helps to prevent the drum catching the dispenser hose.

    February 4, 2015 at 3:43 pm #424393
    admin
    Keymaster

    Re: ISE 23W Washing machine problems

    http://shop.ukwhitegoods.co.uk/05ise03-ise2-washing-machine-drum-bearing-kit

    ISE bearing kit

    Bryan

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.