Beko going into full speed spin immediately.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko going into full speed spin immediately.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 4, 2015 at 11:42 am #84287
    Madmac
    Participant

    Mod is WM74135W. Checked tacho mag for cracks and continuity in wiring right back to board. Thinking duff triac, has anyone had any success in curing this fault ❓

    Thanks,

    Eddie.

    March 4, 2015 at 7:14 pm #425296
    Seamy
    Participant

    Re: Beko going into full speed spin immediately.

    New board

    March 4, 2015 at 9:12 pm #425297
    Madmac
    Participant

    Re: Beko going into full speed spin immediately.

    Seamy wrote:New board

    Where’s the fun in that though? I like to get me soldering iron hot and beat the system if at all possible 🙂

    March 5, 2015 at 7:44 pm #425298
    Seamy
    Participant

    Re: Beko going into full speed spin immediately.

    Good on ya, I never go down to component level, but i’d imagine its a triac that is shorted, not definite though as i’ve never tested any of them.

    March 6, 2015 at 8:42 am #425299
    Madmac
    Participant

    Re: Beko going into full speed spin immediately.

    Cheers for the reply, I’ll have a look at the triac and see if I can crack it before I price a board.

    Eddie

    March 6, 2015 at 8:37 pm #425300
    bruce118
    Participant

    Re: Beko going into full speed spin immediately.

    Have had many of these with a cracked tacho magnet.
    I have replaced the magnet with one from old hotpoint FHP (AEG type) motor.
    To achieve this you have also to remove the brass part left on the shaft of gage Beko motor and tap on the replacement magnet. Fits a treat. 😀

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.