lamona hja 8704

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › lamona hja 8704

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 10, 2015 at 4:21 pm #84354
    eng14
    Participant

    hi all this machine wont start and in the off position will not switch off and wont reset.she is switching off at wall.richard. 😕

    March 11, 2015 at 11:13 pm #425463
    aqualectric
    Participant

    Re: lamona hja 8704

    The selectors on these are prone to this type of erratic behavior. Before you change it, spray it liberally with switch cleaner with the nozzle fitted. Unplug the small edge connector and get the nozzle in there. Then move the selector knob round and round while you are spraying; wait a couple of minutes for the solvent to evaporate, then reconnect and try it.
    Cured 80{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} + doing this…..

    Also the push button pads on the control panel break on their frame for a pastime. Look carefully at the buttons; they should all be the same height. If they are not, then remove the PCB assembly from the back of the control panel and take the PCB out of the button frame. The start button pivots will be snapped and possibly the tactile switch on the PCB may be displaced depending on the brutality of the customer. PCB and button frame are available separately.


    Steve.

    March 12, 2015 at 6:31 pm #425464
    eng14
    Participant

    Re: lamona hja 8704

    thanks steve will try it,richard.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.