- This topic has 1 reply, 2 voices, and was last updated 10 years, 11 months ago by
.
-
Posts
-
Hi,
Looking for some advice on the below issue.
We can no longer select any setting other than Synthetics if we move the dial to another i.e. spin the LCD screen changes but rather than saying spin 20 mins it has no heading and still says 1.37 which is the time for Synthetics.
We tried putting on spin and ignoring the screen hopeing it would just spin but it started to run a wash (presumably a synthetics one)
Any advice would be most welcome.
Many thanks for your time in advance.
Re: Selector Problem With Beko WM 7127 S
bust knob /knob pin? you would need to strip fascia panel down and remove the display/control pcb, very fiddly and very easy to break the plastic lugs that hold everything in place. For obvious reasons unplug before unscrewing anything. possible the potentiometer that the pin fits in which is part of the pcb has worn/been damaged if they are ok, which is a bit more expensive.
- You must be logged in to reply to this topic.