Bosch WAS 28460GB/04 Dead

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WAS 28460GB/04 Dead

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 13, 2015 at 2:45 pm #85522
    smeghead
    Participant

    Hi All

    No display lights on this, power to front board ok.
    Anyone got exp’ on these.

    Is the board plug and play ?
    The board is in 2 parts , power board & user board.

    Anyone???
    Thanks
    Clive.

    July 13, 2015 at 7:47 pm #428791
    nomadPaul
    Participant

    Re: Bosch WAS 28460GB/04 Dead

    There is a quirk with these machines where one of the smaller components , if it fails , can cause the symptons you describe. Try disconnecting each component individually and see if the board magically lights up. The 3D sensor at the rear is a favourite but it can also be the valve , pressure switch etc

    July 14, 2015 at 7:28 am #428792
    smeghead
    Participant

    Re: Bosch WAS 28460GB/04 Dead

    Ok, thanks- will go back & give it a try.
    Not sure what the 3D sensor is though!!

    July 14, 2015 at 1:02 pm #428793
    nomadPaul
    Participant

    Re: Bosch WAS 28460GB/04 Dead

    The 3D sensor helps prevent uneven loads from spinning by monitoring the movement of a magnet attached to the top rear of the tub. Its on the opposite side to the valves at the rear.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.