Hoover DYN9164DPG/L1-80 loom

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover DYN9164DPG/L1-80 loom

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 31, 2015 at 10:59 am #85694
    smeghead
    Participant

    Hi

    Anyone know if you can get a wiring loom motor plug for this m/c.
    Its just a couple of wires have dropped out, connect do a complete loom for about £50, seems a bit steep

    Thanks
    Clive

    August 1, 2015 at 9:06 am #429283
    aqualectric
    Participant

    Re: Hoover DYN9164DPG/L1-80 loom

    Presuming you know which wire goes where, can’t you individually cut and re-tag each wire with insulated tags? The motor plugs are 6.3mm ordinary male amp tags so should be possible.

    HTH,

    Steve.

    August 3, 2015 at 3:35 pm #429284
    smeghead
    Participant

    Re: Hoover DYN9164DPG/L1-80 loom

    I did think of doing this Steve, but the motor terminals run pretty close together & i didn’t wanna risk tags touching.
    Have quoted customer for new loom now.

    August 4, 2015 at 9:13 am #429285
    keithwilliams
    Participant

    Re: Hoover DYN9164DPG/L1-80 loom

    did this fault throw up any mysterious error codes?
    thing is I had one recently showing e45 which doesn’t exist.
    I ended up referring them to hoover.
    ta

    August 4, 2015 at 3:58 pm #429286
    smeghead
    Participant

    Re: Hoover DYN9164DPG/L1-80 loom

    na, no error code, just filled then no drum action.
    Clive

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.