- This topic has 1 reply, 2 voices, and was last updated 10 years, 8 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
JLTDH14 91609680300 John Lewis /Zanussi dryer
Power going into machine but no lights and no action
It can only be the PCB unless you tell otherwise.
They told me they paid £499 3 years ago, I thought they were making a mistake until
They showed me the receipt, it was only when I looked up machine I realised it was a
Heat pump dryer.
Anyone come across this.Re: J Lewis heat pump Dryer, Dead
if power is getting to the pcb i would first check power supply on the board. normally power goes in through a low ohm resistor (47-100 ohms ) then onto the power supply chips. check this resistor to see if its blown
also check, before you touch it too much, if its covered by any extended parts guarentee
dave
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.