- This topic has 5 replies, 2 voices, and was last updated 10 years, 8 months ago by
.
-
Posts
-
My hotpoint w/m when switched on is struggling to fill with water, the super wash light, easy iron and door locked light are stayin on. Any ideas on what the problem could be. I checked the pressure switch and it seems to be working, any help would be hugely appreciated. Cheers.
Re: Hotpoint w/m hvl241 s/n 712040330
Difficult to say, error codes are given by flashing the lights not keeping them on steady. Do those lights not cancel when you press the buttons as they are selectable option buttons.
What happens if you set it to spin?
Re: Hotpoint w/m hvl241 s/n 712040330
Hi, sorry they are flashing, it will do a full cycle but it’s very very slow taking in water.
Re: Hotpoint w/m hvl241 s/n 712040330
F12 error code. Communications error, if you are very lucky it will just be loose connections between the two circuit boards. The plugs are quite weak. You need to check and squeeze the small plugs gently to see if that cures the fault.
If that doesn’t cure it then one of the pcb’s may be faulty. be sure to remove the mains plug first.
Re: Hotpoint w/m hvl241 s/n 712040330
Cheers for that, would it be wort getting a new circuit board?
- You must be logged in to reply to this topic.