zwd1480w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zwd1480w

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • September 3, 2015 at 12:13 pm #85996
    dopper
    Participant

    had a blocked condenser which I cleaned out, now got e10 code but there is a water feed from the valve, anyone advise
    dop

    September 3, 2015 at 7:00 pm #429987
    Martin
    Participant

    Re: zwd1480w

    Is there lots of crud on the bottom NTC ?

    September 4, 2015 at 8:12 am #429988
    dopper
    Participant

    Re: zwd1480w

    I did clean it out but will have another look

    September 4, 2015 at 8:17 am #429989
    dopper
    Participant

    Re: zwd1480w

    would that stop power to the valve?

    September 4, 2015 at 12:15 pm #429990
    Martin
    Participant

    zwd1480w

    dopper wrote:would that stop power to the valve?

    Oops no sorry, I got mixed up with E20. 🙁

    E10 yet water flows from the valve through the condenser does it?

    September 10, 2015 at 7:22 am #429991
    dopper
    Participant

    Re: zwd1480w

    sorry late getting back yes the water is flowing

    September 12, 2015 at 1:44 pm #429992
    dopper
    Participant

    Re: zwd1480w

    CHECKED THE NTC AT BOTTOM HAD SCALE ON IT SO CLEANED IT UP TESTED IT FOR 15MINS EMPTY WORKED OK, SHE PUT A LOAD IN AFTER 10MINS E10 AGAIN! WOULD A FAULTY NTC AT THE BOTTOM CAUSE THAT?

    September 12, 2015 at 3:36 pm #429993
    Martin
    Participant

    Re: zwd1480w

    It could simply be the inlet valve as the coil can act intermittently when it gets warm. Works OK cold then after a few minutes goes O/C. And unless the valve (or coil) are replaced you won’t know for sure.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.