- This topic has 0 replies, 1 voice, and was last updated 10 years, 6 months ago by
.
-
Posts
-
Hi,
our Bosch Logixx 8 1200 varioPefect seems to have developed a fault. End of last complete cycle gave a strange error, no code but – -, same place where -0- would normally be for cycle end or — for rinse hold.Door lock still in place, so had to release manually.
drain pump had a some junk in it but is clear now and still get the same results. Motor is brushless, so no worn brushes, belt is fine and when you go through any cycle it seems to work fine apart from not rotating or spinning. The motor control is sending some signal to the motor as it rotates around 1/8 turn a couple of mins into a new cycle with the belt removed. Drum rotates freely and as you go through the cycles there are various noises from the relays, so doesn’t look like a mechanical issue
Any ideas?
- You must be logged in to reply to this topic.