Beko wme7267 washing machine

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Beko wme7267 washing machine

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 3, 2015 at 1:37 pm #86279
    mjw1208
    Participant

    Have got a Beko wme7267 washing machine with a strange fault – Switch on and lcd display only shows 0021 in minutes section ,no temp or spin speed shown ,have tried to reset it by turning control to cotton setting then switching off and then holding in start/cancel button for 5 seconds etc. then it goes into spin mode at 1600 speed and counts down so far so good. However after it finishes the machine still refuses to do anything – no fill or pump action am I looking at a faulty main board ??? any ideas would be helpful thanks

    October 4, 2015 at 1:41 pm #430691
    simon26r
    Participant

    Re: Beko wme7267 washing machine

    Hi. I have two bekos with the same problem. As far as i could see its the main pcb

    October 5, 2015 at 9:38 am #430692
    mjw1208
    Participant

    Re: Beko wme7267 washing machine

    Yes that’s the conclusion I came up with regarding the main pcb , as all the usual suspects appear to be ok

    October 12, 2015 at 9:39 am #430693
    mjw1208
    Participant

    Re: Beko wme7267 washing machine

    Had the main pcb checked by EMW no fault found ,refitted with new programme control and all working now ok . So it would appear the programme control itself may have been at fault .

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.