NEFF W5440X0GB/27

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › NEFF W5440X0GB/27

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 12, 2015 at 2:49 pm #86358
    franz
    Participant

    This machine gets stuck at 1 minute to go , suspect element but when meggered shows 660 Mohms and 26.2 ohms resistance when metered .
    Is this a high enough resistance or is it something else?
    Thanks Franz

    October 12, 2015 at 3:43 pm #430879
    Martin
    Participant

    NEFF W5440X0GB/27

    The element’s not brilliant but passable. What of the motor though? Any hint of an earth leak there can cause time-out. So too the pump not draining fast enough though that is far less likely.

    October 13, 2015 at 7:07 am #430880
    franz
    Participant

    Re: NEFF W5440X0GB/27

    works ok on rinse ,so suspected the element.
    Franz

    October 13, 2015 at 4:58 pm #430881
    timdowning
    Participant

    Re: NEFF W5440X0GB/27

    660 Mohms, the heaters fine!!

    Did you check the thermistor wiring where it is tied to the tub? If wiring is ok then I change the thermistor as a matter of course. Then it only leaves the module that could be your problem.

    October 14, 2015 at 2:59 pm #430882
    franz
    Participant

    Re: NEFF W5440X0GB/27

    Thanks Tim, replaced thermistor , now working fine.
    Franz

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.