Servis Dishwasher M4608AL

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Servis Dishwasher M4608AL

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 23, 2005 at 3:06 pm #8645
    Twoten
    Participant

    Went to this machine due to blowing fuses. Found the ‘solonoid’ device on the dryer unit behind the control panel. This can not be purchased from Servis as a seperate part only as a complete dryer unit at about £80.
    The same type of device is used on a few detegent dispensers.
    Does anyone know if any company supplies these things individualy?
    Also does anyone know what they are actually called?

    Thanks,

    Keith.

    March 23, 2005 at 4:12 pm #129798
    Dave_Conway
    Participant

    Re: Servis Dishwasher M4608AL

    Check RS Components Kieth, I think they do them.

    http://www.rswww.com

    Dave.

    April 1, 2005 at 5:37 pm #129799
    robbra
    Participant

    Re: Servis Dishwasher M4608AL

    Hi, be careful as this solenoid can burn a hole in the stainless inner door and cause the machine to leak and fuse. had this twice under guarantee. Good luck
    Rob

    April 5, 2005 at 5:49 pm #129800
    goosegreen
    Participant

    Re: Servis Dishwasher M4608AL

    Some Bosch dishwasers use these devices on there soap dispensers dont know if they are sold as seperate item though I think they use the same technolagy as solid state fridge relays PTC?

    April 7, 2005 at 8:16 pm #129801
    sene
    Participant

    Re: Servis Dishwasher M4608AL

    I have’nt seen this solenoid, but talking about Bosch dishwasher soleniods, the PTC solenoid can be purchased seperately.

    April 9, 2005 at 9:55 am #129802
    Twoten
    Participant

    Re: Servis Dishwasher M4608AL

    As I couldn’t be sure if I sourced the device from a different supplier that would fit and I couldn’t get a seal to fit between the device and blower unit either. On top of this I was just about to go away to the sun for a week so I quoted for the complete unit to be on the safe side. I would rather this than fit a part and have further problems. Due to the price of the part the cusomer descided not to have the work done.

    Thanks for all the advice anyway,

    Keith.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.