- This topic has 1 reply, 2 voices, and was last updated 10 years, 4 months ago by
.
-
Posts
-
Bosch WAS24460GB/08. FD9010.
This machine will light up, lock door, start program run for around five minutes and then goes dead as if the plug has been pulled. There is power at the selector switch plug on the PCB at all times. Then after a few moments, you can turn the dial off then on and it all comes back to life.
Anyone had this problem before?
I noticed from the Bosch parts site that there is a display board with a separate power board sandwiched behind it. There is also an inverter board in the base of the machine.
I think it is possibly the control panel power board at fault as when the machine is live everything works OK; but the mains supply plugs into the display board selector switch not the power board hence the hesitation.Any information would be helpful, thanks!!
Steve.
Re: Bosch WAS24460GB/08 goes off…then on…
sounds like a board power supply fault
if you have enough knowledge you can remove the board and check the dc output after the board fails. if it drops to zero or very low its prob the power supply chip. happens on a lot of machine i had a dead miele with this fault the other day
look in the sticky at the top of this forum for other examples
Dave
- You must be logged in to reply to this topic.