adg7540 dishwasher w/pool

This topic has 1 reply, 2 voices, and was last updated 10 years, 3 months ago by dopper.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
December 14, 2015 at 10:11 am #87027

dopper
Participant

pump was gone fitted new one, now 9 flashes after a few mins washing anyone point to what that would be, seen code says continuous fill
dop

December 14, 2015 at 5:39 pm #433718

Criscold
Participant

Re: adg7540 dishwasher w/pool

– Close water tap and check if F9 still occurs. If so, exchange flow meter.
– Measure resistor of water inlet valve (WV1) ca. 3,5k?. WV1 should be closed.
– Check if Output of control board (CB) is permanently switched on. If so,
exchange CB.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.