Hotpoint wt960 inlet valve

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Hotpoint wt960 inlet valve

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • December 16, 2015 at 7:30 pm #87060
    Washdisher
    Participant

    Hi Folks,

    It’s the type that pushes into the dispenser, but suppliers inc Hotpoint are unable to give me a correct part number. I have photos but can’t work out how to attach them. The terminals are approx 180 deg (probably more like 170/190 deg depending on which way round you go) from the outlets that plug into the dispenser. The terminals are the small pin type. Any help much appreciated.

    Derek

    December 16, 2015 at 8:21 pm #433849
    iadom
    Moderator

    Re: Hotpoint wt960 inlet valve

    C00112661. 😉

    December 16, 2015 at 10:11 pm #433850
    Washdisher
    Participant

    Re: Hotpoint wt960 inlet valve

    Hi Iadom,

    Thanks for your help. This is the one I bought after discussions with Hotpoint but it is the wrong one. I should have mentioned that the outlets take the flow through ninety degrees, and that the inlet and outlets follow the same line.

    Derek

    December 17, 2015 at 9:36 am #433851
    iadom
    Moderator

    Re: Hotpoint wt960 inlet valve

    Checked again and Partfinder is wrong. 😕

    Try QUAVAL 32 from Qualtex.

    Or look HERE

    December 17, 2015 at 8:02 pm #433852
    Washdisher
    Participant

    Re: Hotpoint wt960 inlet valve

    Hi iadom, Thanks for your suggestions, but unfortunately the terminals are in the wrong position and would foul the soap box. Thanks for trying but I think I’ll have to advise my customer to buy a new machine.

    Regards, Derek

    December 17, 2015 at 8:41 pm #433853
    iadom
    Moderator

    Re: Hotpoint wt960 inlet valve

    The solenoids are easily moved to any position you want them.

    December 17, 2015 at 9:56 pm #433854
    Washdisher
    Participant

    Re: Hotpoint wt960 inlet valve

    Thanks, I’ll give it a whirl!

    December 17, 2015 at 10:22 pm #433855
    iadom
    Moderator

    Re: Hotpoint wt960 inlet valve

    Just ease them up slightly with a flat bladed screwdriver and turn them to the position you need. Or if needed you can remove the solenoid completely and turn it round ‘end to end’ to reposition it.

    January 7, 2016 at 12:59 pm #433856
    Washdisher
    Participant

    Re: Hotpoint wt960 inlet valve

    Hi Iadom,

    Never knew you could do that. Thanks for your help. Got it sorted just before Christmas but not had chance up until now, to thank you

    Derek

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.