Gc2224gekb American

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Gc2224gekb American

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • December 21, 2015 at 11:05 am #87100
    Cras
    Participant

    Any help on this ,I attended this fridge freezer to find the evap fan not running , only 24 v to fan motor ,I have by passed evap trip and door switch and fitted new p c b but the problem still persists any pointers on this thanks Cras

    December 21, 2015 at 1:59 pm #433961
    melec
    Participant

    Re: Gc2224gekb American

    Is that one of those motors that has the stator completely covered in plastic ?
    Doesn`t even look like a motor apart from the fact there is a fan stuck on the end of a steel shaft?
    Has a twinned plug assy (rather than normal L/N supply)
    If so I do not remember them being much more than 24V dc motors so supply is good and motor is faulty

    December 21, 2015 at 3:45 pm #433962
    admin
    Keymaster

    Re: Gc2224gekb American

    Hi

    It will be the motor assembly..We hold them in stock

    Bryan

    December 21, 2015 at 6:40 pm #433963
    Cras
    Participant

    Re: Gc2224gekb American

    240 volt motor on this ,tried a 240 volt Hoover evap motor across just in case ,still no joy

    December 27, 2015 at 8:57 am #433964
    melec
    Participant

    Re: Gc2224gekb American

    Does it have a module to control the defrost cycle or a mechanical timer ?

    December 28, 2015 at 10:12 pm #433965
    burns
    Participant

    Re: Gc2224gekb American

    From my experience on these, the evaporator fan fails very rarely. But when it does it will take down the jazz board (pcb) mounted in the top of the fridge. You can usually see signs of melting around the coils on the fan. Change the fan motor first, if not it will soon take out the new pcb. Been there and done that….

    December 30, 2015 at 7:49 am #433966
    ELDAR59
    Participant

    Re: Gc2224gekb American

    I’ve had the evap fan motor going almost short on these and then frying the board by taking too much power.
    I’d be checking the resistance of the fan and I’m sure that will show you the issue.

    cheers.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.